2000-2020 Tacoma, Fan speed, temperature, and defroster dial (2002-2006 Tundra)

I see this has been made few times by other people but there are a couple of features on some models that were left out that I took care of. This model does have the light and direction indicator. this model also has the locator nub on the bottom to ensure the operator does not pass the hard stops. this can be seen in the last picture. Square drive opeing is oversized by .008 in both the x and the Y dimensions. Please print adjust the flow for your printer accordingly.

Print settings
100 Percent infill
layer height is .16mm
overlap on my print was 25%.

Build plate was loaded at an angle and supported with tree supports for anything that was creaing 30 degrees or less of overhang. have the numb down so the part behind the nub is also supports and make sure you print the part on an angle so no supports get stuck up the drive