Ball-Joint FIlament Guide

The original is meant to be placed on the Creality K1 MAX printer from behind where the PTFE tube outlet is. But I like the idea so much I have already put it on many different printers I have, with universal mount ( the Squared one), which you just put where you want with double sided tape so you don't even need screws for it. 

The angle of the ball joint is set once the compress cover is screwed on, I have had 0 trouble with the setup after 6 rolls of filament, it didn't even move. 

 I have basically used only the supports on the plate and just for the arm as there is curved angle. You don't even need to do that, all higher end printers will do it even without supports.

Use 4 walls at least.

You will need:

-2x M3x10mm Screws, nuts are not necessary, if tolerances are good on your printer.

-Some double-sided Tape ( just for the universal printer version )

-2x Additional screw M3x8mm for the Creality K1 MAX ( Here you don't need the tape obviously )

-1x PTFE Push fit Connector 4mm