Voron Bowden Retainer with Fittings and Panel Clip

I was done with the reverse bowden falling off the retainer so I added ECAS04 bowden fittings (remove the rubber piece on the back as usual). I also added a panel clip tab to the front of it so it can replace two parts into one.

Note: the two tubes are touching edge to edge inside the mount, make sure they are properly cut to ensure smooth passage of the filament. 

BOM:

• 2x ECAS04 bowden fittings
• 1x 30mm SHCS
• 1x T-nut (can be recycled from your original panel clip or bowden retainer)
• 2x bowden tube