drain spacer for sink repair

The drain plug for this sink should have had two positions - open and closed.

The open position was achieved by a spring loades ball (you see it on the picture) that held the plug in the open position - but this never worked since the plug was too heavy for the ball.

With this spacer it prevents it from closing automatically - so its always open and this is the only position that i need

Printed in PETG with 0.2 mm and 15 % infill

The Diameter of the plug shaft is 8mm (when pressfiting the spacer - open it a little bit up with a 8 mm Drill) - The outer diameter of the plug i use is 50 mm (the spacer has 60mm)

If it is useful for you please leave a like