Moulding Stand for Turn Racing Porsche 911 992 Cup GT3 Cup

This stand makes it easier to mould the Turn Racing grips for their excellent Porsche 911 992 Cup GT3 Cup wheel by Zebbebab. Simply use two 20mm M5 bolts, 2x M5 washers and 2x M5 nuts to secure the inverted wheel plate to the stand.

Disclaimer

When you start this 3D printed project and use this guide, you're agreeing to the following:
This guide is here to help and inform you. While I’ve worked hard to make it accurate, I can't guarantee it's perfect or completely free of errors. The success and safety of your project ultimately depends on your own skills, good judgement, and following proper safety procedures.  If you're ever in doubt, I strongly recommend asking for advice on the DIY Sim Racing Workshop Discord.

You're building this project at your own risk. I cannot be held responsible for any damage to property, injuries to yourself or others, or any other losses that might occur from using the instructions in this guide, from any errors in the guide itself, or from the construction and use of your 3D printed creation.

It's your responsibility to:

• Be careful and use appropriate safety gear.
• Understand the potential risks and limitations associated with 3D printing, electronics, 
  and any other tools or materials you use.
• Follow all relevant safety guidelines and best practices.
• Double-check any information or instructions before you proceed.
• By using this guide, you agree to release me from any claims for damages, injuries, or losses that might come up as a result of your involvement in this project.