The Ultimate Cereal Container Filament Drybox - Coupler Cap Remix

I found the original coupler cap too loose on the ptfe coupling and my filament wasn't fitting very well in the hole. Since there wasn't a step file I just modeled this from scratch. Besides not following his design 1:1 the major changes are listed below.

Here is what's changed:

• 9.9mm coupling diameter (coupling should be about 10mm)
• 2.05mm filament hole diameter
• Redesigned the handle to make it even easier to print the overhangs.

If you would like to request any changes I am happy to accommodate; I have also included the step file to save you some time if you would like to remix yourself.

Print Settings:

• TPU 95a or softer
• .2 layer height
• standard settings (2 wall, 15% infill etc etc)
• NO SUPPORTS NEEDED