WD-40 Aerosol Can Straw Clip

After seeing one I wanted a straw clip to fit all the WD-40 cans that I had and after next to zero searching I decided to make my own

Its should work for most 660mm diameter recessed rim cans

I did print this on my A8 as the tolerances might be off on an actually good 3d printer

Print at 0.1mm layer height (the stl should have the correct orientation)
Make sure you pick a material that is resistant to the solvent that is in the bottle or expect to be replacing these every so often

I did print this on my A8 as the tolerances might be off on an actually good 3d printer
Try scaling the part if there are problems

(Ill test it on my V0.1 when I get to it)