Voron V0 LED rail

This mod is a LED strip holder for the Voron V0 3D-printer. It should hold any 10mm wide LED strip, but I used it with RGB WS2812 Individually Addressable LEDs. I used a 30 LED/meter (low density) strip to fit 5 LED per side. To make the wiring easier, I put them in parallel (see the wiring diagram in the files).

The LED are fully controllable by the firmware. I included a sample configuration Klipper file for the SKR mini E3 V2.0. I recommend making the LED macros easily accessible by using the Octoprint "Sidebar Macros" plugin (eg: On Full brightness, Off, On dim, ...).

Parts required per rail (double for each side; quadruple for both sides):

• 2 M3×8 BHCS screw

• 2 M3 nuts

Note: M3 nuts must be inserted on the inner side of the top extrusion. Fortunately, this can be done with minimal disassembly!

Other mods on my Voron V0:

• VORON V0.1 CR10 Hotend (Mini Afterburner mod) by me (https://www.thingiverse.com/thing:5239499)

• The Ultimate Spool Holder by filamentry (https://www.thingiverse.com/thing:2047554)

• V0 handles slim by Ch4rlesB (https://github.com/VoronDesign/VoronUsers/tree/master/printer_mods/Ch4rlesB/V0_Handles_Slim)

• AC input connector skirt by me (https://www.thingiverse.com/thing:5239634)

• A Raspi Camera support by me (to be published)

Print Settings

Printer:

Voron V0

Rafts:

No

Supports:

No

Resolution:

0.2 mm

Infill:

30%

Filament:

Geetech ABS

Black

Notes:

Print in ABS, no support required.
Note: this part fits in the V0 printing volume.

Mods installed on my VORON: https://www.printables.com/@CGrassin_217772/collections/3301830

Category: 3D Printer Parts