February 11, 2022
Description
This collapsible tripod for your phone will handle all of your Zooming needs. It's easy to print, requires no supports and no additional parts.
Features:
-The three legs simply snap into sockets in the tripod base
-A screw ring is use to set the leg angle anywhere from collapsed to fully open
-The threaded post, when fully extended, can tilt forward and backwards by 30 degrees. When stowed in the base, it can be held in place by a clip on one of the legs.
-The screw knob at the top both clamps your phone in place between the jaws and also sets the friction level for tilting forward and backwards.
-Both jaws and the leg with the clip have tiny break-away support structures built-in. No need to turn on your slicer's supports. Just print as-in and break away.
Print one of each part except for print two of the plain legs. Assembly is straightforward - just use the photos as a guide.
Printer Brand:
MakerGear
Printer:
MakerGear M2
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2mm
Infill:
20%
Filament:
Inland PLA
Notes:
The leg with the clip and the jaws all have tiny built-in support structures with clearances that require slicing with exactly 0.2mm layer height. Just break away these small pieces after printing.
License:
Creative Commons — Attribution — Share Alike
LoboCNC
