February 11, 2022
Description
This zip tie anchor is a redesign of PeterEllens' version (http://www.thingiverse.com/thing:24187) but I've made a little change so that it prints easily without supports. I've also included a small notch in the bottom to make it easy to pry off the built table. It is 1" square - simply apply a piece of 1" wide double-sided foam mounting tape to the back and you'll have a secure mounting point for small to medium sized zip ties. You can also scale it by 75% if you want to use 3/4" foam tape.
Printer:
UDIO
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
30%
Category: PartsLicense:
Creative Commons — Attribution — Share Alike
8
LoboCNC
