Greaseweazle v4.1 3.5 Inch Disk Drive Enclosure

This is an enclosure for the v4.1 Greaseweazle and a 3.5 inch floppy disk drive. This only works with the 4.1 greaseweazle board. 

Requires 4 m3 x 12mm screws to hold the drive into the enclosure and 2 m3 x 8mm to attach the back cover on the enclosure (though you can probably use 12mm ones there too). And 2 m2.5 x 6mm screws will hold the pcb into the back of the enclosure.

There should be enough room below the floppy drive to stuff the excess ribbon cable. 

Print settings:

Print enclosure with the front face down on the bed as shown in the photos.