Deep Crimper Pegboard Holder - 25mm Deep 50mm Wide

This pegboard crimper holder is deep enough for the thicker crimpers used on Dupont connectors and some models with interchangeable crimping bits.

In addition to those types of crimp tools it's useful for attaching a variety of RJ45 Cat5 ethernet network wire crimp tools to peg boards.

Print instructions

Category: Tool Holders & Boxes Print Settings

Printer Brand: SeeMeCNC

Printer: Rostock MAX

Rafts: Doesn't Matter

Supports: Doesn't Matter

Resolution: .2mm

Infill: 30%

Notes:

This printed well with PETG, ABS, and PLA on the Rostock max. Some of the PLA parts were a bit too brittle although that might be a factor of the heat setting being too low and not enough infill. PETG and ABS seemed to be reliably sturdy.

Instructions

Using the following options:

holder_y_size = 25
holder_height = 15
strength_factor = 0.66
holder_offset = 0.0
taper_ratio = 1.0
holder_angle = 0.0
corner_radius = 10
holder_cutout_side = 0.0
holder_x_count = 1
holder_x_size = 50
closed_bottom = 0.0
holder_y_count = 1
wall_thickness = 1.85