June 12, 2025
Description
Use this at your own risk and be safe.
1 rack has 4 mounts with 2 thin mounts supporting(66cm from the side) the middle section and the bigger mounts on the side.
Houses 1KG spools/boxes and up, should be able to hold 3KG spools.
300mm+ printer is required to be able to print these.
I printed these in PLA, for hot climates i would look into other filament.
If you are planning to use 3KG spools make sure to use plenty of walls and infill to stiffen them up.
Files are made to house 20mm tubes at 2M length, mine are painted in black measured at 20,20mm giving it a very snug fit.
Longer should be possible if you add extra support prints.
Bare material should move more freely, if it's a bit too tight you can scale them up with 1 or 2%.
Video about the build can be found here:
License:
Creative Commons — Attribution — Noncommercial
Noizie Works
