VORON 2.4 G2XL Stealth Skirts 350 - Cheese Grater & Hexagon (tighter fit remix for 350 R2.4 only)

This is a remix of PrintStructor's original VORON 2.4 G2XL Stealth Skirts 300 & 350 - Cheese Grater & Hexagon.  

The changes were requested and tested by another Voron builder, who is working on a 350 R2.4 build.  The primary reason for this remix is to tighten the spacing between the skirt components, so each center module has been widened by a very small amount.  The side fan modules also have the hole spacing updated to 50x50mm, since they were just slightly off from that measurement when I checked them in the CAD files.  The models here are specific to the 350mm Voron R2.4.  Aside from being very slightly wider, these are otherwise it is identical to the original design:

https://www.printables.com/model/1201260-voron-24-g2xl-stealth-skirts-300-350-cheese-grater/ 

Note that these remixed models includes the a remixed (widened) pitft50 V2.1 screen mount, but does not include other screen display mounts.  The models are not oriented for printing, so please adjust them as needed in the slicer.

To decide if your build may benefit from these models, I suggest first printing the stock corner skirts and installing them.  Then measure the gap where the center sections would go (for example where the rear center, front display and side fans will go).  Finally, compare those measurements for the center modules to the following widths for the remixed models provided here:

Side fan skirts (updated fan hole pattern 50x50, widened):
Skirt_Remix_7_Fan_Mountl_x2_194-15mm.stl - 194.15mm wide
Skirt_Remix_7_Fan_Cover_x2_194-15mm.stl 

Rear Center 350 module (widened):
skirt_remix_v5_350_rear_center_219-8mm.stl - 219.8mm wide
skirt_remix_7_350_rear_center_inlay_logo.stl - this is an optional part, but is very tight

Front Display module (widened version of the stock pitft50 v2.1 screen mount):
skirt_remix_v5_screen_139-5mm.stl - 139.5mm wide

Thanks and Acknowledgements:

The modification was suggested and tested by  Steiner-Se, who is building an 2.4 R2.  The changes were a collaboration, and required some trail and error to get the gaps just right, so thanks to Steiner-Se for the idea, and for testing the changes.  Any images of the printed models are also courtesy of Steiner-Se.
 

This remix took a bit of work to get dialed in, but it is overall a very small change to the original, so if this works for you, please give the original a like, and consider supporting the original designer PrintStructor:

The original design is here:
VORON 2.4 G2XL Stealth Skirts 300 & 350 - Cheese Grater & Hexagon. 


I have a number of other Voron related models, which you can find here.

If you find these models useful, please post a like or a comment with some pics of your prints. 

You can find the other things I'm working on at my blog here.  You can also follow me here on Printables or MakerWorld, to see what new stuff I post.  

Thanks for looking!