February 11, 2022
Description
This is an adjustable picture hanger, to be combined with:
You'll need two of these hangers attached to a wall, with the nails pointing up, to hang a picture. The screws let you adjust how far the nails stick out and you can adjust them until the picture frame is perfectly level.
Rafts:
No
Supports:
No
Resolution:
0.1mm layer height
Notes:
I printed this on a Formlabs Form 1 with Clear resin v2 at the 0.1mm layer height setting. I printed it directly on the plaform, flat side down, without any supports.
This was modeled in Autodesk Fusion 360. You can get the original model here: http://a360.co/1Jxg4MO.
Category: DecorLicense:
Creative Commons — Attribution
Marc Liyanage
