Magnetic Earplug Case

This is a carrying case for "Moldex Spark Plugs" earplugs. Will likely fit similar earplugs that are up to 25mm long.

Even though these are the “throwaway” kind of earplugs, I'd like to reuse them a few times to reduce waste. This allows to carry and store the earplugs when not in use.

Bill of materials :

• 2 M2x12mm screws (shorter ones are fine too, but dont go shorter than 6mm)
• 6 3x2mm magnets

Print settings I used:

• 0.4mm nozzle
• 0.15mm layer height
• no supports
• 2 perimeters
• 15% gyroid infill