February 13, 2022
Description
I was blown away by the cost of an OEM Waist Level Finder for my Mamiya 645 Super. I don't use one often but when you want one you want one. So I came up with this. I will probably replace the front tabs with 1mm stainless once they break off. I didn't round any of the edges just so it prints easier. May update later. Lens is from a Old Kodak Slide projector 37mm. Pins are 1/16" stainless - a Jumbo paper clip straighten may also work.
Printer Brand:
Prusa
Printer:
Prusa Clone
Rafts:
No
Supports:
Yes
Resolution:
.15
Infill:
20
Filament:
eSun PLA+
Notes:
Print the base flat with support to baseplate only - be careful of tabs when removing support. speed 40 on base 60 on everything else. 20% infill
License:
Creative Commons — Attribution
Madog541
