December 18, 2025
Description
Love this design? 💖
If you enjoy this aesthetic, please consider supporting my new project, KamiMarks!
While this design looks good here, if you want a printed one (that looks much better), you can find them at KamiMarks.
And it's not just bookends! You'll also find bookmarks, book trackers, and more accessories for your manga, books, and shelves!
Bookend of Son Goku and Vegeta (2 units) | Dragon Ball Fan Art 🐲
Figure to the left, figure to the right, base to the right and base to the left are included.
Figure thickness: 3 mm.
Measurements (figure+base): 180 x 142 x 81 millimeters.
Weight: ±120 grams.
It can be printed without AMS by adding the breaks in the layers exposed below and changing the filament, although it is easier using the AMS.
It can be printed with a 0.4 mm noozle. Actually, the files are optimized for 0,4 mm noozles.
Four colors are needed for the figure: black, dark gray, silver/light gray and white. I recommend printing the base in black.
The figure fits in the slot of the base and has to be glued. There are two versions:
Right: this is the one for Vegeta.
Left: use this for Goku.
To glue the figure to the base I recommend a transparent glue such as Bostik 820 and avoid Loctite / Super Glue, as it can cause white stains as a result of the glue curing in humid environments.
To improve adhesion, I recommend adding four silicone tears to the bottom of the base, as shown in the photos. You can find them at any DIY or stationery store.
Print made and verified using Recyled PLA from Smart Materials:
- Black
- Dark gray
- Silver
- White
No, you cannot.
Recommended print settings 🖨
Perimeter generator: Arachne
Layer height: 0,2 mm
Perimeters loops: 1
Top layers: 1
Bottom layers: 1
Top layer pattern: Monotonic
Bottom layer pattern: Monotonic
Infill Density: 100%
Infill pattern: Rectilinear
Solid inner infill pattern: Monotonic
Platform Adhesion: None
First Layer: 50 mm/s
First layer infill: 105 mm/s
Outer perimeter: 200 mm/s
Inner perimeter: 300 mm/s
Low dense infill: 270 mm/s
Inner solid infill: 250 mm/s
Top solid infill: 60 mm/s (this one is key!)
For the base, use your default configuration for solids with a 15% infill. I recommend using cross-hatch or gyroid and slow down the speed in order to avoid any problem in the upper layers.
Start with black
At layer 10 (2 mm) swap to dark grey.
At layer 11 (2,2 mm) swap to grey/silver.
At layer 13 (2,6 mm) swap to white for the rest.
License:
Standard Digital File License
3D Manga Panels
