Elegoo Centauri Carbon Side panel spacer

I added to  a heat isolation pad all of metal side panel (lef, right, back)

I hop cause an higher inner temperature for ABS and ASA printig.

Use cheap Chinese: "Heat Insulation Cotton 3D Printer Heating Bed Sticker"

The thickness of the thermal insulation pad is 8-10 mm. So I have to raise the side panels by 5 mm to keep them at a safe distance from the moving parts.
I tried to make a simpler and more material-saving solution.
It was printed with PETG filament so that it would not deform due to the higher temperature.

Attention! the pieces are not divided symmetrically, so when assembling, proceed in order according to the numbers on the part, clockwise.

If you need a thicker spacer, simply resize it in slicer without keeping proportions and increase the z value to the desired size.

For the 5mm thickness I had to replace the side screws. I used M3x8 for this