this is an end cap for the camper Bürstner Club 360 (1995)
| DESIGN DECISIONS |
it is modeled following the dimensions and form of the original part (white one on the pictures)
I only added an additional support for the chimney part where the screw goes through - that was the thing that was breaking the most on the original part
the part is tested on a camper Bürstner Club 360 (1995)
| PRINT SETTINGS |
supports are needed - there are 3mf files with supports for Prusa MK4s and Prusa Core One
the print in the pictures (gray) was printed on ELEGOO Saturn 4 Ultra 16k and i attached the presupported models for it
General settings (FDM):
0,10 - 0,15 mm layer height
10-15% Cubic infill
2-3 perimeters
print in PETG, ABS or some other plastic that is stronger and/or heat resistant
Sedak
