K2 Plus Cartographer USB and PTFE Clips

This is a remix of the “mini clip” from SHaDoW6.  The biggest change was adding the cutout for the Cartographer USB cable to engage into.  I also made the flanges a little longer to improve the grip.

I noticed that the stock PTFE tube wasn't long enough to follow the route of the energy chain entirely.  So I have some TH3D PTFE tubing on order to make the tubing and cable follow the route fully.  I'll try and post some photos when the complete install is done.

I printed in PC because it's what I had loaded, but I would suspect that ABS, PETG, or anything other than PLA would work fine.  PLA may work too, but I'd be concerned about the clips releasing if the chamber is heated.

No special settings are needed for this print, but I used the following with the standard 0.20mm profile in Orca:

• Layer Height: 0.2
• Arc Fitting: On
• Precise Wall: On
• Wall Loops: 3
• Detect Thin Walls: On