Replacement part for side window handle of a HymerMobil (Mercedes 601 based)

One of the handles to open, close and lock the side window of my father-in-law's mobile home was broken/ missing. The handle is equal on both sides, so I could “copy” the remaining one.

The “handle part” of the unit is only roughly similar as the original part - the important bottom part was measured and should fit. (Reference pint are the mounting holes).

I printed the part in PLA - as a prototype - for later I would suggest PETG or even ABS to survive the (possible) high temperatures in a car in summer…

PS: The photographs are made of a pre-version, there as one detail missing. The final model is shown in the rendering…

PPS:
The “+1mm wide version” is easier to install in the car.