Dust collection adapter DN100 - 2*DN40

Dust collection adapter from an incoming 100 mm hose to two 40 mm hoses.

I use this on my router table to connect both the fence and the router itself to my dustcollector. Works fine with @MariusHornberger 's hose clamps.

You have to print 1 x the base piece ("Grundkörper"), 1 x the 100 mm connector ("Stutzen DN100") and 2 x the 40 mm connector ("Stutzen DN40"), then assemble everything with a bit of superglue.

The middle screw is a bit hard to get to, if you don't have a long and thin screwdriver. It holds fine with just two screws, though.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0,2 mm

Infill:

Filament: any PLA or PETG any

Category: Parts