Betafpv Pavo Femto O4 Drone Case

While I made this model completely from scratch, credit where credit is due. I got the inspiration from this particular model: https://www.printables.com/model/1231690-betafpv-pavo-femto-storage-femto

The previous one was sized for 450mAh batteries and it did not fit my 550 ones. The fit was also a bit loose and the drone would bounce around a bit too much for my taste.

I also used the clips from another project: https://www.printables.com/model/39729-tool-box-parametric

I suggest you cut a piece of the thinner foam from the original box and glue it to the inside of your cover like I did for extra protection.

This case will fit:
4x 550mAh BetaFPV Batteries (tattu 550 and 450 ok as well)
1x Set of replacement 1611 40mm props

I printed it in Polymaker ASA with 4 Walls and 25% Gyroid Infill