Vanderhall Glovebox Knob fits over key

This is a knob that slides over your glovebox key to hide the key and create a better looking knob that can be left in place.  I printed mine in PETG.  I pushed my key into it right after it was printed.  It was a tight fit for the key.  I used pliers to push it all the way in. It required a little pit of working side to side.  If you have issues pushing your key in then I suggest heating the knob some with a hair dryer or heat gun right towards the slot the key pushes in.

I printed this on a Bambu Lab P1S  I also used adaptive layer height to better handle the radiuses.

I printed this with the opening facing down and I used supports.

You could also sand and paint the knob for a better appearance.   This fits my CompX National Key C346A