Prusa Core One Side Storage (20x5x2 Magnets)

I found it difficult to source the same 20x6x2 magnets that Prusa uses in the USA, so I remixed the side storage design to accept these 20x5x2 magnets (actual dimensions closer to 18.9 x 4.6 x 1.8 mm).

Required hardware:

• 29x 20x5x2 magnets
• 2x M3x20 screws (same as original)

I also moved the magnet slots a bit closer to the surface of the model so they stick to the CORE One a bit better. I would like them to stick a little stronger even, but not enough to remix the model again. 🙂

NOTE: Photos show magnets sticking out a bit reference, but the slots are deep enough for them to be fully seated in the printed part.

Along with the remixed files, I've copied the necessary unchanged files from the original model for convenience. In the photos, you'll also see a deeper bottom tray which can be found here.

I printed this with some multicolor painting with MMU3. The attached 3mf file included all the models (except the deeper bottom tray) with the multicolor painting applied.

Onshape link in case you want to remix further.

Thanks to Prusa Guy for the original model AND for providing STEP files so it is easier to remix.