K2 Plus Build Plate Alignment Blocks Remix

I tried the original design several times, but it kept breaking on my during install.  The tabs would snap off or it would split at the layer lines.  I probably could've scaled it very slightly to work, but I wanted to give this a shot instead.

I printed this in PC because it's been my inexpensive go-to filament for higher temp items.  But any PC, ABS or other high temp material should work I think.

I printed using the following settings in Orca on my Qidi Plus 4:

• Layer Height: 0.20mm 
• Arc Fitting: On
• Precise Wall: On
• Wall Loops: 2
• Sparse Infill Density: 15
• Sparse Infill Pattern: Cross Hatch
• Enable Support: Off

I doubt any of these settings are very critical, but I just wanted to share what worked for me.

I've added the .3mf files as well as the .step files so people can make changes as they want.  But if there are any improvements to be made, please let me know.