W114 Watch Enclosure for the Heltec T114 v2

This is a case for the Heltec T114 V2 for you to wear as a watch. It works great with the upcoming 2.7 firmware that gives you a watchface.

Materials Required

• Heltec T114 V2 nEF52840 (Amazon - affiliate link)
• 1x 502030 LiPo Battery 3.7v w/ MICRO-JST CONNECTOR (Amazon - affiliate link)
• 1x OEM coil antenna
• 1x NATO-spec watch strap of your choice (Amazon - affiliate link)

Printing Instructions

• Print for strength settings in whatever material you prefer.
• Place the face of the main case facing the print bed
• Place the back of the cover facing the print bed
• Enable thin wall detection

Assembly Instructions

1. Place the button print into the case.
2. Connect the antenna and battery to the T114 v2.
3. Place the T114v2 port-first into the case. Gently snap into place, ensuring the board is laying flat.
4. Place the antenna into the case above the T114v2.
5. Place the back cover on the case, and gently snap it into place.
6. Run the “tail” of the NATO watch strap through the two watchstrap slots, then on the shorter “head” of the strap, run the tail through the first band to secure the strap to the watch.
7. Wear and enjoy!