July 25, 2025
Description
While upgrading the antennas on the GoFilm20 with TrueRC Singularity antennas i needed to make something that would hold them in place a bit better so they don't flop over.
I created this small brace intended to surround the antenna cable and hold it as high up as possible.
Print in TPU, and slide it into the stock openings. I trimmed down the top edge a tad for the length of antennas i had, you may or may not need to do so
Placed flat on the bed it should be printable without supports.
License:
Creative Commons — Public Domain
8
joshhetland
