Simple Pull Door Handle - No supports needed!

Smooth, rounded, sturdy pull door handle attached with two screws.

1 inch of space between the wall and the handle inner edge. Smooth, rounded pull surface. Chamfered top edge for thumb to push against while opening.

Printing Instructions

Print in your preferred material with as much infill as you like, but here are some print settings recommendations:

• 20% or higher infill should be plenty strong
• Supports disabled
• Print the handle in the orientation of the model, so the flat edge of the outside of the handle is on the print bed. This allows for printing without any supports.

Once configured:

1. Print the model on its flat edges toward the outside of the handle, with no supports.
2. Take it off your print bed when it's done. Boom.