Subaru Forester SG 06-08 Foglight Air Ducts

This model is a replacement for the stock foglights on 2006, 2007, 2008 SG Subaru Foresters. I made them for my track-ready forester so that I can plumb brake ducting to the front rotors.

These fit into the factory foglight mount points. You'll need to use one panhead screw (or a screw with a washer) where the pre-made hole is. You should even be able to re-use the one you'll have after removing the stock foglights.

Fits 3" air ducting hose.

Print instructions:

• Mirror the model in your favorite 3d printing model for the opposite side
• Requires supports (I used tree mode which worked well)
• I printed in PA6-CF just because. I'm sure ABS or ASA would work perfectly fine, too.

I suspect I may be the only person in the world to want/need/use these--if you happen to use them yourself, leave a comment so I feel better about not being the only crazy person racing a Forester XT as a track car.