XSHOT Pro Motorized Piston Pump Toy Dart Blaster by ZURU 90 Deg Battery Compartment

Wanted to add a small 90 degree battery compartment for the new XSHOT Pro Motorized Piston Pump Toy Dart Blaster by ZURU

1. Print the lid where the tabs are facing up.
2. Print the battery case upside down with support for the screw only.

I use minimum 4 walls and 15% infill.

Once printed, assembly is to pass the wires through the hole in the screw and then slowly screw the part on. At the end there will be a little force to get past the 45 degree angle on the battery compartment to slide into its final rotation.

The lid locks into recessed inserts on the inside of the battery compartment and a thumb screw holds it in place. 

Hardware Required:

1. M3x14mm screw for the thumb screw