Safariland QLS plate with Amomax Holster Mount

Hardware

To attach the Amomax hoster to this I would recommend an M6x14mm countersunk bolt.

Versions

There are two versions, standard and non-standard.

Standard

Standard uses the normal mounting solution with that bit at the top that bends back around and secures with the locking lugs on the QLS plate. This is more secure and sturdy, but is much harder to print as either way you would end up with loads of support material.

More suitable for MJF/SLS printing services. I had mine printed at JLCPCB for around $10 and it works perfectly.

Non-Standard

The non-standard version uses a different design with two small prongs that go out either side. It does the same job and is much easier to print as you can just print it flat on its back. but it does mean you are relying on the QLS plate tabs not to bend out.

More suitable for FDM printing.