Spyder's MPP Front Shroud ( X-shot AEB motorized piston pump )

If you enjoy my creations/remix, feel free to support me via buy me a coffee-
https://buymeacoffee.com/spydergiant

This is my own X-shot MPP shroud that I modeled and designed to try to make it look as factory"ish" as possible.

Side plates are printed separate so people can have color break on the shroud and not have to use AMS or MMU and waste an absolute ton of filament. 

Toolless attachment to your blaster. slide the front on, slide the upper rail on, then put the pin in the upper rear part of the rail so that it hooks into the picatinny on the blaster itself. Slide the lower rail on and put the smaller pin in the back to lock it into place. I have had zero issues with it coming out.

Included is the longboi and short king version for whatever floats your boat. I made the shortking to make mine into a CQB monster with the minimal rear stock found on printables (I will be remixing at some point)

Print front end down and support this section in green

No steps to be available at this time.

Thanks to Je (flipflopfoamfactory) @shoelesshisto_427318 for the borrowed dovetail and rails

and @ChrisStrong_2921182 for the base inspiration that ended up turning into the ship of theseus when all was said and done. I basically redrew everything.