3.5" Hard Drive Mount Slider Bracket for a CoolerMaster PC Chassis

I drew this model from an original bracket that came with the Cooler Master PC case. Other models that I found online were too long and did not fit into my case.

The bracket works for the left and right side.

PLA may become soft or deform due to heat. Rather print with PETG, ABS or some other material that can handle higher temperatures.

PRINT SETTINGS:

• Print on its side
• Paint support only on the under-side of the notch - no other support needed.
• Outer brim recommended (the long narrow contact area can easily become loose during printing)