February 22, 2022
Description
A very simple 40mm fan mount for the Raspberry Pi.
You will need standoffs to mount to the RPi itself. I used 18mm high standoffs.
Obviously using 5v fans you can power it off the RPI 5v/Gnd GPIO pins.
I printed it with Esun ABS+, 4 walls, 5 layers top & bottom and 100% infill.
Takes about 25min to print.
It shrinks a little using ABS+ and the fan holes became a little tight to mount the fan but it does fit.
Worked for me.
Category: 3D Printer AccessoriesLicense:
Creative Commons — Attribution
7
Jason
