Arduino Spot Welcher V4 Case - Remix Mark 1

This is a Remix from the original model with improvements.

https://www.thingiverse.com/thing:4781310

Changes to original:

• moved/resized some of the openings to get a better fit on my hardwareboard/display/buttons/pins
• overall rounded to get rid of some sharp corners (handling) and inside for better print quality/speed
• added text description into the top case model (will be printed with bridges - no supports!)
• usb port protection build into the model
• many more...

TIP:

For better positioning of the hardware pcb, use the nylon nuts to adjust the height a bit. Other than that, what helped me: wind some tape around the big wire on the position, where the case will be closed and have the pass-through. This will center the wire a bit more, that should leads to a better positioning of the pcb in the top case.

Print

Print in PETG since it can withstand a higher temperature - if it gets warm (thats why alot venting holes + fan is in there) 0.2mm height with a 0.4mm nozzle and no supports.

Added - copper pin holder

I've measured my wire ends where the copper pins are crimped on, then designed a fixture to get the aligned next to each other. So you can use it with one hand instead of two. 2pcs of M4x12mm DIN912/ISO4762 are used.

Category: Parts