Replacement Latch/handle for Regalo Easy Step 36" Extra Tall Walk Thru Baby Gate

This replaces the original handle on the gate for when it cracks and breaks. This only works with the original version of the gate with the red lock at the end of the handle(See picture). It was modified slightly from the original design to allow it to be more durable, print easier, and remove any unnecessary complexity.

I do not recommend PLA/PETG, I have used that in the past and they only last a couple of months before the pins break off.

Print Settings

• 100% infill

• supports and brim

• Print in ABS/ASA

Installation Instructions

• Remove the old broken handle 

• save the nut and bolt

• slightly stretch the new handle over the gate to get it to fit into place

• reuse the old nut and bolt to attach the new handle

• don't tighten too much, only until the locknut is engaged. Threads will be flush with the end of the lock nut.