Porsche 718 GT4 Flat Face Style Front

This is a direct replacement of the front plate and button covers for Zebbeba's excellent 911 Porsche Cup/718 GT4 steering wheel (https://www.printables.com/model/337685-turn-992-cup-diy-sim-racing-wheel).

This replicates the earlier flat style of the earlier Porsche 718 GT4 (similar to the one in iRacing).

Versions with and without a cut out for a 39mm Porsche badge are included, as are versions for smaller printers.

It is recommended that you print this with both an outer brim and supports to reduce the likelyhood of warping.

Disclaimer

When you start this 3D printed project and use this guide, you're agreeing to the following:
This guide is here to help and inform you. While I’ve worked hard to make it accurate, I can't guarantee it's perfect or completely free of errors. The success and safety of your project ultimately depends on your own skills, good judgement, and following proper safety procedures.  If you're ever in doubt, I strongly recommend asking for advice on the DIY Sim Racing Workshop Discord.

You're building this project at your own risk. I cannot be held responsible for any damage to property, injuries to yourself or others, or any other losses that might occur from using the instructions in this guide, from any errors in the guide itself, or from the construction and use of your 3D printed creation.

It's your responsibility to:

• Be careful and use appropriate safety gear.
• Understand the potential risks and limitations associated with 3D printing, electronics, 
  and any other tools or materials you use.
• Follow all relevant safety guidelines and best practices.
• Double-check any information or instructions before you proceed.
• By using this guide, you agree to release me from any claims for damages, injuries, or losses that might come up as a result of your involvement in this project.