Benchy Wreck at Sea - Diver Edition [2 Models]

2 Models Available here (read note below)

A Benchy lost at sea! The diver was only gone 10 minutes, what happened? Was it JAWS again? We might never know. It's a very long swim home!

I'd suggest using blue filament for the sea and then whatever you'd like for the broken hull. I used dark grey. Infill was 15%. I used PLA. I did set this model to 0.15mm height to give the hands of the diver the best chance. I'm sure 0.2mm would do fairly well.

Supports: I did have to use tiny supports, on the divers chest and back to hold the first lower lines of his helmet. A small pliers was enough to gentle remove them.

2 Models available: Diver facing away from the Benchy wreck, or the diver facing towards the Benchy wreck.
Note the STL or Project File when downloading!

Want more variants?
Click here for the regular Benchy Wreck at Sea model.
Click here for the alternative Benchy Wreck at Sea - JAWS Edition
Click here for the alternative Benchy Wreck at Sea - Iceberg Edition [2 Models]