Honda Del Sol Sail Panel Receiver Clips

This is a replica of the sail panel receiver clips that go into the body so the sail panel can be held into place. I haven't installed these yet to test but they should fit perfectly since I replicated them from an OEM clip.

IMPORTANT: You will need to use silicone or your choice of sealant to put under and around the clip to waterproof it, the factory ones came with a rubber gasket and obviously this doesn't have one.

PRINT SETTINGS:

PETG recommended for strength but PLA will probably be ok too

Print Slow like 60mms for max layer adhesion

4 wall loops

.20 or .24 layer height (.24 has a little better strength)

Supports needed

If you would like to leave a tip for my hard work you can do so here :D https://www.paypal.com/ncp/payment/Y5DRF7PN8S5AJ