Necessary tools/materials:
- Original USB cable attached to the Glo Hyper Pro
- Allen key
- 2pcs M4x8-16 allen key bolts
- Soldering iron , heat insert tool
- 2pcs M4 heat inserts (max 8mm long)
- optional: 2pcs magnets (6x18x20mm max)
Printing:
- Scale:
PLA/PETG - 100%
ABS/ASA - 100,5-102% (depends on material shrinkage) - Walls: 4
- Infill: 10-20%
- No supports
Assembly:
- Set the 2 heat inserts in the Glo Top piece flat or deeper. (if you set it deeper you might have to use longer bolts)
- Remove any remaining burr.
- Optional: drop 2 magnets in the slots of the Glo Bottom (or use glue/doublesided tape etc…)
- Thread the USB cabel trough the Bottom piece T shape then push it in the Top piece and slide them together until parallel.
- Screw in the bolts.
I was printing the :
Orange :
- eSUN eSilk-PLA Jacinth
- Generic PLA Rapid settings
- infill: 15% Honeycomb
- scale: 100%
Black:
- Prusament ASA Prusa Galaxy Black
- Prusa ASA settings
- infill: 15% gyroid
- scale: 100,5%
- Fuzzy skin : Contour, Voronoi: Points:0,3mm Thickness:0,2mm Feature:1mm
Magnets glued to the bottom so they don't rattle.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
Nutterflies
