Roll-Up Rose for Small Print Bed (Prusa Mini+ / 180x180mm)

Sharing these files to make it easier for anyone with a small print bed who wants to make one of these roll-up roses. Overall, the model is scaled down 80% with a minor modification to the thickness of the rose petal part.

Follow the same instructions as on the original rose model page.

The center of the rose was the only file specifically modified as a brim wasn't enough to stabilize it during printing. Remove the additional square of material from the bottom of the pin after printing.

Notes:

• I found that using super glue to keep the petals wound up was necessary.
• At this scale, the rose is a bit top heavy, so using a heavier/taller vase or shortening the rose stem might be a good improvement.
• I used this vase scaled down to 40mm diameter.