Volvo V70 Door Lock Ring Snug Fit

This is a complete redesign, from the ground up in Freecad, of my original Volvo Door Lock Ring that has been optimized for printing with a 0.4 nozzle and snuger in-the-door fitment. Also, with more control, and a lot of practice, i was able to recreate a more accurate part to the original.

Reason? It turns out, leaving your car outside in the heat of summer has the unintended effect of annealing your printed parts, hence the new part with tighter fitment to the door, and more sturdy and effective retention.

Print Settings:

Printer:

Prusa MK4S

Enclosure:

Not necessary 

Filament:

Tested with PETG

Layer Hight:

0.15

Infill:

N/A

Exterior Perimeters:

5

Brim:

Inner brim only

Brim width,  about 1.3mm

Heated Bed:

Yes

Supports:

Yes

Snug 

Approximated Filament Usage:

0.33 (m)

Approximated Print Time:

7 minutes on stealth