February 26, 2022
Description
Plate for mounting an autolevel inductive sensor on a CTC PI3 Pro B.
The sensor is an inductive probe SN04-N.
You will need to mod the GT2560 motherboard to connect it to the sensor. Put a male pin on the 5v pad, and solder right angle male pin to the mosfet GND (see photo). The sensor line goes to the bottom pin on z-max. You will need Repetier firmware instead of Marlin.
You will need two 50mm M3 screws to reach to the other side of the extruder plate.
Category: 3D Printer PartsLicense:
Creative Commons — Attribution
7
Jesse
