Whetstone Wedge

Yet another wedge for whetstone but this wedge 

• sits rather tight (for 25x50 cross-section whetstone) and 
• can be printed without support.

Printing:

• lay flat side down
• no supports
• 3 walls (outer, inner, outer)
• 7% infill
• PLA+

Rule of Thumb: 

• 10° for kitchen knife
• 20° for pocket knife

Note that the whetstone board belongs to the sink. The feet shall tightly fit the sink below dripping water, so you have all hands free for sharpening.

See also the FreeCAD project file on GitHub: wedges.FCStd.