Ford Maverick Nintendo Switch FITS Slot Adapter Mount with Adjustable Orientation

Ender 3

Yes

Lightning, 40% (Please use cubic or something strong instead)

----------v1.1 Edit---------

----------ORIGINAL NOTES--------

OK, to print this thing is pretty straightforward. I used lightning infill (new to Cura 4.12) which greatly helps getting prints done quickly for taking pictures of, and has little to no structural integrity. Please use Cubic at a percent of your choice. Likely 20-40% will do. Print in PETG.

• The ball just prints in place. The tolerance for the switch holder is large enough for everyone's printers whether they're dialed in or not. The more dialed in you are, the higher the potential to slide a little piece of paper in the groove to tighten it up will be. No big deal.
• The switch holder prints in place. If you're feeling brave, you shouldn't need supports for those large gaps. Even if it sucked a little, it wont affect the strength or design in that spot.
• The Screw cap has a MAXIMUM layer height of 0.2mm.
• The FITS slot piece is the only odd duck. I printed it upright, and used a SUPPORT BLOCKER (thats the last option on the left of cura) to block supports for being make for the actual screw part. Boom done. You might be able to print this slot on its back with supports, but I wanted to ensure the screw didn't run rough when tightening. You do you.

Congrats! Hopefully your kids/passengers think you're as cool as mine do [this week] -- its the little things. 🤪