Kirby Food Ninja Steam Redirector (Pressure Cooker Kitchen Cupboard Saver)

Ok, PHEW. This is a remix of a lot of things. My wife ran across a dragon head version of this (hi! Thank you! Awesome creation!) and we're... we're more Nintendo people, so after searching extensively for a model of Wario with his mouth wide open and farting (cause that was my original intended creation that didn't happen) I settled on Kirby spewing steam with his mouth wide open.

The design is simple. Slide the steam nub into any of the 4 holes on the bottom. I've (since the photo shoots) offset the nub holes to accommodate shooting directly into your face instead of onto the counter next to you. My wife said, and I quote, "I'd rather burn my face off than have to clean the counter again" - so that was an executive decision that was not to be undone. :D

So, stand clear, and use his little arms to carefully open the steam valve when your meal is done, and watch him spew steam for 5 minutes while it depressurizes.

QUESTION: What about the melting point? Wont this just melt in half if I use PLA?

ANSWER: PLA is what I used. Wet heat melting points are much different than Dry heat melting points; You shouldn't need to worry. If you're nervous, print it in PLA+, PETG, etc.

You'll need some supports, but they're not terrible to remove. Takes a minute or two.

Please. Enjoy.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

.2

Infill:

Filament: COEX PLA WHITE

Category: Kitchen & Dining