September 11, 2025
Description
No special print recommendations, clean build plate for good adhesion, mouse ears or brim if corners lift, 10% rectilinear infill for speed, doesn't require exceptional structural support.
With above settings approximately 600grams of filament needed.
Design available as a whole for those blessed with large enough volume
or
Split model available fits on MK3/4/CoreOne with snap connectors. Recommended using glue to permanent hold.
Designed to hold 13, 6" diameter, 1mm thick diamond plated laps. Features 20mm catch all tray for dops or whatever. Intended to hold an entire line up of laps required to go from roughing to high polish, 120/240/600/1000/1200/1500/2000/2500/3000grit + 4 Copper laps for final polishing (or some other combination).
Affiliate links below.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
9
ClearMindCasting
