September 9, 2025
Description
Layer height: 0.2 mm (0.16 mm for finer details)
Perimeters (walls): 3 (≥1.2 mm)
Top/Bottom layers: 4–5
Infill: 20–30% (Grid or Gyroid)
Supports: Required
Brim/Raft: Optional – use Brim if you experience warping
PLA: easiest to print, fine for indoor use if not exposed to strong sunlight
PETG: best balance for car use – strong, heat resistant, and easy to print
ASA/ABS: highly UV and heat resistant, but harder to print (warping, fumes)
👉 PETG is recommended for car interiors exposed to sunlight.
Orientation: print upside down, with the opening facing the build plate (mouth down)
Cooling: on for PLA, low for PETG/ABS
Finishing: light sanding and clear coat can give a glossy finish
Recommended for artificial flowers only – safer while driving.
If you want to use natural flowers, insert a small inner tube/test tube for water.
License:
Creative Commons — Attribution
10
Daniel Max Dragomir
